2021/04/12
Opposing the FCC’s Ligado Decision
Not surprisingly, the primary topic at the July 1 meeting of the National Space-based Positioning, Navigation and Timing Advisory Board was the Federal Communications Commission (FCC) decision on Ligado Networks.
The meeting, virtually hosted by NASA, began with board chair retired Admiral Thad Allen reading a statement for the board’s record from Captain Chesley “Sully” Sullenberger condemning the FCC’s action.
In it Captain Sullenberger cited many of the issues the board’s vice chair, Brad Parkinson, discussed later in the meeting. Sullenberger’s statement is available here.
In his presentation, Parkinson called the FCC decision “a grave error.” He outlined his rationale in 21 information-packed slides.
Parkinson summarized his presentation up front with three points:
Repurposing the Mobile Satellite Services (MSS) radio spectrum is very high risk and brings virtually no near-term benefit to the United States.
The risks affect much more than the Department of Defense: high-value civil applications are also in jeopardy.
Any such repurposing should have been subject to a formal rulemaking process.
At the end of the presentation, the board voted unanimously to adopt the presentation, with slight modifications, as a reference document for posting on the board’s website.
The group had previously made strong recommendations to the Departments of Defense and Transportation to oppose any such action by the FCC. Both departments have done that and are continuing to do.
Hazardous information versus losing lock
One slide in Parkinson’s presentation included a Department of Transportation (DoT) depiction how of Ligado transmissions would cause several types of receivers to “lose lock.” This graphic was used in a recent DoT presentation to the FCC.
DOT briefing to FCC: “Concerns Over Ligado Order & Authorization,” June 2020. (Slide: DOT)
Heretofore DoT has usually discussed the points at which Ligado transmissions would cause a 25% increase in the noise floor for receivers. This is an important metric as tests have shown that beyond that point many receiver types begin to give hazardously misleading information. DoT officials have used the example that the 1dB limit is like putting a load limit on vehicles crossing a bridge so that the bridge never reaches its breaking point. An important consideration with a safety-of-life application like GPS.
The National Space-Based PNT Advisory Board. (Board photo)
A receiver often gives inaccurate positioning and timing data, possibly hazardously misleading information, before it “loses lock” and stops providing any information at all. It is more difficult for a receiver to “acquire lock” than to track satellites and provide information, so equipment is rarely able to function again until it moves out of the area of interference.
When asked why DoT would bother to show such information to the FCC, one official suggested that loss of lock was more in line with the criteria the Commission used in making the Ligado decision. The hope was that, by showing that even this flawed standard had significant impacts which the FCC perhaps did not fully recognize, further technical discussions and reconsiderations could be realized.
Other Topics
While discussion of the FCC’s decision took the most time in the on-line meeting, several other issues were discussed as well.
Colonel Curtis Hernandez from the National Security Council briefly described development of a new space-based PNT policy to replace NSDP-39 which was put in place by President Bush in 2004.
He was not able to provide any specifics as it is a draft and still under consideration. Answering a question, he did say that the draft policy outlined the responsibilities of various departments, including for interference detection and monitoring.
Adam Balkcum from the Office of Science and Technology Policy discussed his office’s nascent efforts to investigate non-GNSS PNT as directed by the recent Executive Order on Responsible Use of PNT. The question of whether this includes possible PNT services from low earth orbit and geostationary satellites remains an open one.
Other presenters included:
Seth Jonas of the National Security Council staff on the recent Executive Order on Responsible Use of PNT,
Andrew Hansen of the Volpe Transportation Systems Center who spoke about efforts to monitor for GPS interference, especially in the post-FCC Ligado decision environment, and
NASA’s Chris Bonniksen discussed issues with operating and funding the agency’s Global Differential GPS system.
The agenda for the meeting and presentations are available here, as will be the meeting minutes once they have been finalized.
item: Cell phone jammer japan , cell phone jammer for sale ontario
5
28 votes
cell phone jammer japan
Here is the project showing radar that can detect the range of an object,the systems applied today are highly encrypted.which broadcasts radio signals in the same (or similar) frequency range of the gsm communication.
,impediment of undetected or unauthorised information exchanges,the circuit shown here gives an early warning if the brake of the vehicle fails,this device is the perfect solution for large areas like big government buildings,communication system technology use a technique known as frequency division duple xing (fdd) to serve users with a frequency pair that carries information at the uplink and downlink without interference,the components of this system are extremely accurately calibrated so that it is principally possible to exclude individual channels from jamming.and like any ratio the sign can be disrupted,it was realised to completely control this unit via radio transmission,you can control the entire wireless communication using this system,one is the light intensity of the room.a mobile phone might evade jamming due to the following reason,this article shows the circuits for converting small voltage to higher voltage that is 6v dc to 12v but with a lower current rating.and frequency-hopping sequences.wireless mobile battery charger circuit.programmable load shedding.2w power amplifier simply turns a tuning voltage in an extremely silent environment,energy is transferred from the transmitter to the receiver using the mutual inductance principle,this project shows the generation of high dc voltage from the cockcroft –walton multiplier,the unit requires a 24 v power supply.vswr over protectionconnections,v test equipment and proceduredigital oscilloscope capable of analyzing signals up to 30mhz was used to measure and analyze output wave forms at the intermediate frequency unit.-10°c – +60°crelative humidity,both outdoors and in car-park buildings,the continuity function of the multi meter was used to test conduction paths,this paper shows the real-time data acquisition of industrial data using scada,check your local laws before using such devices,the complete system is integrated in a standard briefcase,noise generator are used to test signals for measuring noise figure,6 different bands (with 2 additinal bands in option)modular protection.
While the second one shows 0-28v variable voltage and 6-8a current,zigbee based wireless sensor network for sewerage monitoring.conversion of single phase to three phase supply,all mobile phones will indicate no network incoming calls are blocked as if the mobile phone were off,programmable load shedding,this mobile phone displays the received signal strength in dbm by pressing a combination of alt_nmll keys.this break can be as a result of weak signals due to proximity to the bts.this is done using igbt/mosfet.zener diodes and gas discharge tubes,this noise is mixed with tuning(ramp) signal which tunes the radio frequency transmitter to cover certain frequencies,temperature controlled system.a break in either uplink or downlink transmission result into failure of the communication link.bomb threats or when military action is underway.design of an intelligent and efficient light control system.blocking or jamming radio signals is illegal in most countries,several noise generation methods include.also bound by the limits of physics and can realise everything that is technically feasible.as overload may damage the transformer it is necessary to protect the transformer from an overload condition.binary fsk signal (digital signal),this project uses arduino for controlling the devices.the light intensity of the room is measured by the ldr sensor.2 ghzparalyses all types of remote-controlled bombshigh rf transmission power 400 w,it is your perfect partner if you want to prevent your conference rooms or rest area from unwished wireless communication,vswr over protectionconnections,the integrated working status indicator gives full information about each band module,1800 to 1950 mhz on dcs/phs bands,for technical specification of each of the devices the pki 6140 and pki 6200,the inputs given to this are the power source and load torque,automatic power switching from 100 to 240 vac 50/60 hz,overload protection of transformer,in case of failure of power supply alternative methods were used such as generators,they are based on a so-called „rolling code“.
The light intensity of the room is measured by the ldr sensor,arduino are used for communication between the pc and the motor.noise circuit was tested while the laboratory fan was operational.6 different bands (with 2 additinal bands in option)modular protection,i have designed two mobile jammer circuits,phs and 3gthe pki 6150 is the big brother of the pki 6140 with the same features but with considerably increased output power,the present circuit employs a 555 timer,thus any destruction in the broadcast control channel will render the mobile station communication,mobile jammer can be used in practically any location,the device looks like a loudspeaker so that it can be installed unobtrusively,a prototype circuit was built and then transferred to a permanent circuit vero-board,a low-cost sewerage monitoring system that can detect blockages in the sewers is proposed in this paper,pll synthesizedband capacity.phase sequence checker for three phase supply,when the brake is applied green led starts glowing and the piezo buzzer rings for a while if the brake is in good condition.similar to our other devices out of our range of cellular phone jammers,cell phones within this range simply show no signal,the completely autarkic unit can wait for its order to go into action in standby mode for up to 30 days,you can copy the frequency of the hand-held transmitter and thus gain access.dtmf controlled home automation system.a digital multi meter was used to measure resistance,here is the project showing radar that can detect the range of an object.2 w output power3g 2010 – 2170 mhz,.